IBM Eserver xSeries 360 Type 8686, User Reference Manual

Page: 120 / 184

106
IBM® xSeries 360: User’s Reference
1800 A PCI/PCI-X adapter has requested a hardware interrupt that is not
available.
Action: 1. Make sure that the PCI/PCI-X adapter and all other adapters
are set correctly in the Configuration/Setup Utility program. If
the interrupt resource settings are not correct, change the
settings.
2. If all interrupts are being used by other adapters, you might
need to remove an adapter to make an interrupt available to
the PCI/PCI-X adapter, or you might need to force other
adapters to share an interrupt.
1962 No valid startup devices were found. The system cannot find the startup
drive or operating system.
Action: Be sure that the drive that you want to start from is in the startup
sequence.
1. Select Start Options from the Configuration/Setup Utility
program main menu. If you are unable to set the startup
sequence, call for service.
2. Check the list of startup devices in the Startup device data
fields. Is the drive that you want to start from in the startup
sequence?
Yes Exit from this screen; then, select Exit Setup to exit
from the Configuration/Setup Utility menu. Go to
step 3.
No Follow the instructions on the screen to add the
drive; then, save the changes and exit the
Configuration/Setup Utility menu. Restart the
server.
3. Is an operating system installed?
Yes Turn off the server. Go to step 4.
No Install the operating system in the server; then,
follow the operating system instructions to shut
down and restart the server.
4. During server startup, watch for messages indicating a
hardware problem.
If the same error message appears, call for service.
2400 An error occurred during the testing of the video controller on the system
board. This error can be caused by a failing monitor or a failing system
board.
Action: Verify that the monitor is connected correctly to the video
connector. If the monitor is connected correctly, call for service.
2462 A video memory configuration error occurred.
Action: Make sure that the monitor cables are correctly and securely
connected to the server.
If the problem remains, call for service.
5962 An IDE CD-ROM configuration error occurred.
Action: Check the signal and power cable connections to the CD-ROM
drive.
If the problem remains, call for service.
Table 12. POST error messages.
POST message Description