IBM Eserver xSeries 360 Type 8686, User Reference Manual

Page: 107 / 184

Chapter 5. Installing options
93
System board connector
This cable connects to the Remote Supervisor Adapter cable connector (J39)
on the system board.
Cabling the server
See “Input/output ports” on page 87 for a description of the I/O ports on the rear of the
server.
The following illustration shows the cable routing for a typical server configuration.
Detailed cabling instructions, including the use of the cable management arm
(shipped with the server) are in the
Rack Installation Instructions provided with the
server.
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. See the documentation that comes with the options for additional cabling
instructions. It might be easier for you to route any cables before you install
certain options.
3. If you have just plugged the power cords of the server into an electrical outlet, you
must wait 30 seconds before pressing the power-control button.