IBM Eserver xSeries 360 Type 8686, User Reference Manual

Page: 157 / 184

Chapter 6. Solving Problems
143
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode
if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water.
• Heat to more than 100
°
C (212
°
F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To replace the battery:
1. Read the information in “Before you begin” on page 51 and follow any special
handling and installation instructions supplied with the replacement battery.
2. Turn off the server and all attached devices, and disconnect all power cords and
external cables (see “Safety” on page vii).
3. Remove the top cover as described at “Removing the server top cover and bezel”
on page 66.
4. Using the illustration at “System board component locations” on page 59 as a
reference, locate the battery on the system board.
5. Remove the battery, as shown in the following illustration:
a. Use one finger to press down slightly on one side of the battery. The other
side of the battery will tilt up out of the socket.
b. Use your thumb and index finger to pull the battery out from under the battery
clip.
c. To ensure that the battery clip will hold the replacement battery securely,
press gently on the clip so that it touches the base of the battery socket
momentarily.
6. Insert the new battery, as shown in the following illustration:
a. Tilt the battery so that you can insert it into the front of the socket, under the
battery clip.