IBM BladeCenter HS12 Type 1916, Service Manual

Page: 70 / 204

To remove the battery, complete the following steps:
1.
Before you begin, read “Safety” on page v and “Installation guidelines” on
page 31.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 33 for instructions).
3. Remove the blade server cover (see “Removing the blade server cover” on page
35 for instructions).
4. If an optional expansion unit is installed, remove the expansion unit (see
“Removing an optional expansion unit” on page 37).
5. Locate the battery on the system board.
Battery (BH1)
6.
Use one finger to press the top of the battery clip away from the battery. The
battery pops up when released.
7. Use your thumb and index finger to lift the battery from the socket.
8. Dispose of the battery as required by local ordinances or regulations.
Installing the battery
Use this information to install a battery on the system board in the blade server.
The following notes describe information that you must consider when you are
replacing the battery in the blade server.
v
You must replace the battery with a lithium battery of the same type from the
same manufacturer.
v To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM marketing representative or authorized reseller.
v
After you replace the battery, you must reconfigure the blade server and reset
the system date and time.
v
To avoid possible danger, read and follow the following safety statement.
58
BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide