IBM BladeCenter HS12 Type 1916, Service Manual

Page: 121 / 204

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
See Chapter 4, “Parts listing, Types 8014, 8028 and 1916,” on page 25 to determine which components are CRUs
and which components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
00151300 MCA: Excessive Recoverable Error Detected
Proc
1.
(Trained service technician only) Reseat the
microprocessor - See “Removing a
microprocessor and heat sink” on page 60 and
“Installing a microprocessor and heat sink” on
page 62.
2. Replace the following components one at a time,
in the order shown, restarting the blade server
each time:
a. (Trained service technician only)
Microprocessor - See “Removing a
microprocessor and heat sink” on page 60 and
“Installing a microprocessor and heat sink” on
page 62.
b. (Trained service technician only)
System-board assembly - See “Removing the
system-board assembly” on page 65 and
“Installing the system-board assembly” on
page 66.
00151350 Processor Machine Check Data a Bank= xx
APIC ID= xx CR4= xxxx xxxx
Additional data for debugging. See error codes
00151100, 00151200, and 00151300 for action.
00151351 Processor Machine Check Data b Address=
xxxx xxxx xxxx xxxx Time stamp= xxxx xxxx
xxxx xxxx
Additional data for debugging. See error codes
00151100, 00151200, and 00151300 for action.
00151352 Processor Machine Check Data b Status=
xxxx xxxx xxxx xxxx
Additional data for debugging. See error codes
00151100, 00151200, and 00151300 for action. If bit 10
of Data b status is set, do not replace the
microprocessor.
Chapter 6. Diagnostics
109