IBM BladeCenter HS12 Type 1916, Service Manual

Page: 147 / 204

Diagnostic messages
Use this information to review the diagnostic error messages and resolve any
errors that might occur in the blade server.
If the diagnostic programs generate error codes that are not listed in the table,
make sure that the latest level of the BIOS code is installed. To download the latest
firmware for the blade server, go to http://www.ibm.com/systems/support/.
The following table describes the messages that the diagnostic programs might
generate and suggested actions to correct the detected problems. Follow the
suggested actions in the order in which they are listed in the action column. In the
error codes,
x can be any numeral or letter. However, if the three-digit number in
the central position of the code is 000, 195, or 197, do not replace a CRU or FRU.
These numbers appearing in the central position of the code have the following
meanings:
000 The blade server passed the test. Do not replace a CRU or FRU.
195 The Esc key was pressed to end the test. Do not replace a CRU or FRU.
197 This is a warning error, but it does not indicate a hardware failure; do not
replace a CRU or FRU. Take the action that is indicated in the Action
column, but
do not replace a CRU or a FRU . See the description for Warning
in the section “Diagnostic text messages” on page 134 for more
information.
BMC self tests
Use this information to resolve BMC self-test errors by referencing the error codes
and following the suggested corrective actions.
Follow the suggested actions in the order in which they are listed in the Action
column until the problem is solved.
Chapter 6. Diagnostics
135