IAI ELECYLINDER EC-S13, Instruction Manual

Page: 109 / 258

3.4 Wiring connections (for connectors)
3-31
3. Wiring
7 mm of insulation should be stripped
from the wire end.
Slightly twist the core wire.
7 mm
Insert the recommended
precision screwdriver
(Refer to table of right)
slowly into the connector tool
insertion slot at an angle.
After fully inserting the wire,
pull out the precision screwdriver.
Caution
Take care not to twist the core wire too far. This will reduce the retention force, causing
the wire to fall out of the connector and possibly causing insufficient current or short-
circuit.
Do not insert the precision screwdriver violently into the connector, or twist it hard. This
may damage the connector housing and internal spring.
If an electric wire thinner than the applicable diameter or wiring longer than 10 m is
used, insufficient current may trigger an alarm and the performance of the
ELECYLINDER may be degraded.
Item Specifications
(1) Shaft
diameter
1.6 ±0.03 mm
(2) Blade
thickness
0.2 ±0.1 mm
(3) Tip angle
length
4.2 ±0.2 mm
Wiring mounting method
Recommended
precision screwdriver