i-SENS i-SmartCare 10, Operator'S Manual

Page: 9 / 133

1. Introduction
8 i-SmartCare 10 Blood Gas Analyzer
Safety
General
Warnings • Use the provided power adapter and power cord only.
• Do not use damaged power cord, power adapter or loose electrical
outlet.
• Do not touch the power supply including power cord and power
adapter with wet hands.
• Please keep the power adapter and the electrical outlet dust free.
• Do not leave any heating equipment or highly flammable materials near
the analyzer or the power supply.
• Make sure to keep the analyzer away from water or any other liquid
substances.
• Do not open or disassemble the analyzer
• Barcode scanner uses an LED light source.
Direct exposure to the infrared light may cause retina injury.
Do not look directly into the light source.
General
Caution • Make sure to connect the power cord to grounded electric outlet.
• Do not cover or block the vent located in the back of the analyzer.
• Do not install or operate the analyzer near the area with strong
magnetic field(i.e: MRI device)
• When the analyzer needs to be stored for a long time, the cartridge
must be taken out.
• Make sure to disconnect the power and to clean the unit before
storage. (
Please refer to 7. Maintenance > Cleaning )
• If the analyzer is inoperable, call the maintenance personel or i-SENS.
• Do not open, dissemble, repair or modify the unit on your own.
• Contact your local distributor for recycling procedure under the
environment protection and resource recycling regulations.