i-SENS i-SmartCare 10, Operator'S Manual, Page: 117 / 133

8. Troubleshooting
116 i-SmartCare 10 Blood Gas Analyzer
Troubleshooting
Guidelines • If the problems described below occur during installation and/or
operation of the analyzer, refer to the solutions as described in this
manual.
• Contact the reseller or service engineer if the recommended solutions
do not solve the problems.
Barcode Scanner • There is no red light for the barcode scanner.
1. Please place a barcode under the part where is labeled.
2. If you still do not see the red light, insert a sharp object (e.g. a
paperclip or a mechanical pencil tip) into the SCAN hole next to the
DISK LED on the back of the analyzer and press once.
3. The scanner may not automatically recognize a barcode in the dark.
4. If the problem persists, please turn off and restart the analyzer.
Note:

Direct eye contact with the infrared light may cause retinal injury.
Do not look directly into the red light.
Screen In case you experience one of the following issues:
• The screen does not respond to touching
• The screen is frozen
• Abnormal screen is conditions are detected
1. Turn off the power.
2. Wait for 10 seconds.
3. Turn on the power back.