CONTROLS AND EQUIPMENT
1- 22
B230G01A-GAT
Installation on Outboard Rear Seats
To install a child restraint system in the out-
board rear seats, extend the shoulder/lap belt
from its retractor. Install the child restraint sys-
tem, buckle the seat belt and allow the seat belt
to take up any slack. Make sure that the lap
portion of the belt is tight around the child
restraint system and the shoulder portion of the
belt is positioned so that it cannot interfere with
the child's head or neck. After installation of the
child restraint system, try to move it in all
directions to be sure the child restraint system
is securely installed.
If you need to tighten the belt, pull more web-
bing toward the retractor. When you unbuckle
the seat belt and allow it to retract, the retractor
will automatically revert back to its normal seated
passenger emergency locking usage condition.
NOTE:
o Before installing the child restraint sys-
tem, read the instructions supplied by
the child restraint system manufacturer.
o If the seat belt does not operate as de-
scribed, have the system checked imme-
diately by your authorized Hyundai dealer.
WARNING:
Do not install any child restraint system in
the front passenger seat. Should an acci-
dent occur and cause the passenger side
airbag to deploy, it could severely injure or
kill an infant or child seated in an infant or
child seat. Therefore, only use a child re-
straint system in the rear seat of your ve-
hicle.
YR10400B
B230B02A-AAT
Using a Child Restraint System with
"Tether Anchorage" System
For small children and babies, the use of a child
seat or infant seat is required. This child seat or
infant seat should be of appropriate size for the
child and should be installed in accordance with
the manufacturer's instructions. It is further re-
quired that the seat be placed in the vehicle's
rear seat since this can make an important
contribution to safety. Your vehicle is provided
with three child restraint hook holders for install-
ing the child seat or infant seat.
Bolt, Holder
(5/16" - 30 mm)
Washer, Conical Spring
Holder, Child Restraint Hook
Retainer Washer
HSM386
