DO-IT-YOURSELF MAINTENANCE
6-18
G200A01A-AAT
CHECKING AND REPLACING FUSES
Replacing a Fusible Link
A fusible link will melt if the electrical circuits
from the battery are ever overloaded, thus pre-
venting damage to the entire wiring harness.
(This could be caused by a short in the system
drawing too much current.) If this ever happens,
have a Hyundai dealer determine the cause,
repair the system and replace the fusible link.
The fusible links are located in a relay box for
easy inspection.
G200A01HP
Bad
Good
Belt routing should also be checked to be sure
there is no interference between the belts and
other parts of the engine. After a belt is re-
placed, the new belt should be adjusted again
after two or three weeks to eliminate slack
resulting from initial stretching after use.
G190A01A-GAT
CHECKING DRIVE BELTS
Drive belts should be checked periodically for
proper tension and adjusted if necessary. At the
same time, belts should be examined for cracks,
wear, fraying or other evidence of deterioration
and replaced if necessary.
Diesel (2.5 TCI)
G190D01HP
G190D02HP
Gasoline
Generator pulley
Idler pulley
Water pump
pulley
COMP.
pulley Auto
tensioner
Crankshaft pulley
Diesel (2.9 CRDi)
Crankshaft pulley
COMP. pulley
Generator pulley
Power steering pulley
Idler pulley
Tension pulley
COMP. pulley
Power steering pulley
Water pump pulley
Tension pulley
Power
steering
pulley
Crankshaft
pulley
Tension pulley
Generator
pulley
Tension pulley
Tension pulley
G180A01A-GAT
CHECKING BRAKE PEDAL
CLEARANCE
You need a helper to check the brake pedal
clearance. With the engine running, have your
helper press down on the brake pedal several
times and then hold it down with a force of about
490N (50 kg, 110 lbs). The brake pedal clear-
ance is the distance from the top surface of the
brake pedal to the asphalt sheeting under the
floor mat. If the brake pedal clearance is not
within the limits specified in the illustration, have
it inspected by your Hyundai dealer and adjust-
ed or repaired if necessary.
SSA6180A
71 mm (2.80 in.)
