DO-IT-YOURSELF MAINTENANCE
6-23
G260A01HP-GAT
REPLACING HEADLIGHT BULBS
Before attempting to replace a headlight bulb,
be sure the switch is turned to the "OFF"
position.
The next paragraph shows how to reach the
headlight bulbs so they may be changed. Be
sure to replace the burned-out bulb with one of
the same number and wattage rating.
WARNING:
Be sure to carefully wipe away any water
drained out in this manner, because the fuel
mixed in the water might be ignited and
result in a fire.
NOTE:
The driver's side headlight bulb can be
changed after lifting the engine coolant res-
ervoir by hand.
CAUTION:
Keep the lamps out of contact with petro-
leum product, such as oil, gasoline, etc.
G260A01HP
Replacement instructions:
1. Allow the bulb to cool. Wear eye protection.
2. Always grasp the bulb by its plastic base,
avoid touching the glass.
3. Disconnect the power cord from the bulb
base in the back of the headlight.
4. Push the bulb spring for removing the head-
light bulb.
5. Remove the protective cap from the re-
placement bulb and install the new bulb by
matching the plastic base with the headlight
hole. Retighten the bulb spring and recon-
nect the power cord.
6. Use the protective cap and carton to dis-
pose of the old bulb.
7. Check for proper headlight aim.
G270A02Y-AAT
HEADLIGHT BULB
G270A01HP
G300B01HP-GAT
REMOVAL OF WATER FROM THE
FUEL FILTER
(FOR DIESEL ENGINE (2.9 CRDi))
G300A01HP
If the fuel filter warning lamp illuminates during
driving, it indicates that water has accumulated
in the fuel filter. If this occurs, remove the water
as described below.
1. Loosen the drain plug at the bottom of the
fuel filter.
2. Tighten the drain plug when water no longer
comes out.
3. Check to be sure that the warning lamp
illuminates when the ignition key is turned to
"ON", and that it goes off when the engine is
started.
If in doubt, consult your nearest authorized
HYUNDAI dealer.
