CONTROLS AND EQUIPMENT
1- 43
B270A01A-EAT
BRAKE PAD WEAR WARNING SOUND
(Not all models)
The front disc brake pads have wear indicators
that should make a high-pitched squealing or
scraping noise when new pads are needed.
The sound may come and go or be heard all the
time when the vehicle is moving. It may also be
heard when the brake pedal is pushed down
firmly. Excessive rotor damage will result if the
worn pads are not replaced. See your Hyundai
dealer immediately.
NOTE:
If the engine were not started within 2 sec-
onds after the preheating is completed, turn
the ignition key once more to the "LOCK"
position during 10 seconds, and then to the
"ON" position, in order to preheat again.
it to a complete stop in a safe location off the
roadway.
After starting the engine, do not drive the vehi-
cle until the vacuum level is above 275 mmHg
below atmosphere and warning light has turned
off. If further trouble is experienced, the vehicle
should not be driven at all but taken to a dealer
by a professional towing service.
B265C02HP-EAT
Diesel Preheat
Indication Light-amber
The indication light illuminates amber when the
ignition switch is placed at the "ON" position.
The engine can be started after the preheat
indication light goes off. The illuminating time
varies with the water temperature.
B265A01B-EAT
Fuel Filter Warning
Light(Diesel Engine)
This light illuminates when the ignition switch is
set to the "ON" position and goes off after the
engine has started. If it lights up whilst the
engine is running, it indicates that water has
accumulated inside the fuel filter. If this hap-
pens, remove the water from the fuel filter.
(Refer to "Owner Maintenance")
B265B01HP-GAT
Brake Vacuum Warning
Light(Diesel Engine)
WARNING:
If you suspect brake trouble, have your brakes
checked by a Hyundai dealer as soon as
possible. Driving your car with a problem in
either the brake electrical system or brake
hydraulic system is dangerous, and could
result in serious injury or death.
The brake vacuum warning light should come on
when the vacuum level in brake booster de-
scends to about 275 mmHg or below. The brake
system is designed to stop the vehicle with
reserve assist if brake pedal is held down. This
reserve is greatly reduced each time you release
the brake. Without vacuum assist your vehicle
can still be stopped by pushing much harder on
brake pedal, however the stopping distance may
be much longer. If the light comes on at any
other time, you should slow the vehicle and bring
Water temperature
(°F)(°C)
Below -22(-30)
-13(-25)
-4(-20)
5(-15)
14(-10)
23(-5)
32(0)
68(20)
Illuminating time
(sec.)
26
20
15
10
5.5
3.5
2
0
