CONTROLS AND EQUIPMENT
1- 17
You can adjust the height of the shoulder belt
anchor to one of the 4 positions.
If the height of the adjusting seat belt is too near
your neck, you will not be getting the most
effective protection. The shoulder portion should
be adjusted so that it lies across your chest and
midway over your shoulder nearest the door
and not your neck.
To adjust the height of the seat belt anchor,
lower or raise the height adjuster into an appro-
priate position. To raise the height adjuster, pull
it up. To lower it, push it down whilst pressing
the height adjuster button.
Release the button to lock the anchor into
position. Try sliding the release button to make
sure that it has locked into the position.
SB090J1-E
Keep Belts Clean and Dry
Seat belts should be kept clean and dry. If belts
become dirty, they can be cleaned using a mild
soap solution and warm water. Bleach, dye,
strong detergents or abrasives should not be
used since the fabric may become damaged
and weakened.
SB090K1-E
Replacement of Seat Belts
The entire seat belt assembly or assemblies
should be replaced if the vehicle has been
involved in an accident even if no damage is
evident. Additional questions concerning seat
belt operation should be directed to a Hyundai
Dealer.
B170A04A-EAT
HEIGHT ADJUSTABLE FRONT SEAT
SHOULDER BELT (Not all models)
B170A01HP.DAG
SB090H1-E
CARE OF SEAT BELTS
Seat belt assemblies must never be disas-
sembled or modified in any way. In addition,
care should be exercised to ensure that the belt
assemblies do not become damaged by being
trapped in seat mechanisms, door shuts etc.
SB090I-E
Periodic Inspection
It is recommended that all seat belts be inspect-
ed periodically for wear or damage of any kind.
Parts of the system that are damaged should
be replaced as soon as possible. Under no
circumstances must any part of the seat belt
assemblies be dismantled or repaired.
WARNING:
o The height adjuster must be in the locked
position when the vehicle is moving.
o The misadjustment of height of the shoul-
der belt could reduce the effectiveness
of the seat belt in a crash.
SB090P1-E
SEAT BELTS (3-Point Type)
To Fasten The Seat Belt
B180A01L-D
The seat belts are fastened by pulling the belt
buckle towards the seat belt stalk and inserting
the metal tongue of the buckle into the stalk.
The buckle should be firmly pressed into the
stalk until locked which will be indicated by an
audible "click".
The length of the seat belt webbing will be
automatically adjusted by the seat belt mecha-
nism to allow the wearer maximum freedom of
