Hyundai Seasall S220P, Workshop Manual

Page: 50 / 150

Engine Mechanical System
49
Cylinder block
6. Install the bedplate bolts.
✍
NOTICE
• The bedplate bolts are tightened in several
progressive steps.
• If any of the bedplate bolts are broken or deformed,
it must be replaced.
1) Tighten the No.18, 20, 21 bolts in its number order
(18
→20→21) with the specified torque.
Tightening Torque:
29.4 ~ 33.3Nm (3.0 ~ 3.4kgf.m, 21.7 ~ 24.6lb-ft)
2) Tighten the No.1~16 bolts in two steps with the
specified torque and angle below.
Do not reuse the No.1 ~ 16 bolts.
Tightening Torque:
61.8 ~ 65.7Nm (6.3 ~ 6.7kgf.m, 45.6 ~ 48.5lb-ft) - 1st
step 120° ~ 124° - 2nd step
3) Loosen the bolts No. 18, 20 and 21.
4) Tighten the No.17~25 bolts with the specified
torque below.
Tightening Torque:
29.4 ~ 33.3Nm (3.0 ~ 3.4kgf.m, 21.7 ~ 24.6lb-ft) - 1
st
step
5) Check that the crankshaft rotates smoothly.
7. Check the crankshaft end play, using a dial
indicator End play Standard: 0.1 ~ 0.3mm (0.0039 ~
0.118in)
8. Using the SST (00200-0T013, 00200-0T012) and a
plastic hammer, tap in a new oil seal (A) until SST
surface is flush with the cylinder block. At this time,
the depth of the oil seal (A) from the cylinder block
surface is 0.8mm (0.032in).
9. Install the flywheel and flywheel adapter
Tightening Torque:
127.4 ~ 137.2Nm (13.0 ~ 14.0kgf.m, 94.0 ~ 101.3lb-ft)