Hyundai Seasall S220P, Workshop Manual, Page: 58 / 150

Engine Mechanical System
57
Lubrication System
Engine Oil
1. Check the engine oil quality. Check the oil
deterioration, entry of water, discoloring of thinning. If
the quality is visibly poor, replace the oil.
2. Check the engine oil level.
After warming up the engine and then 5 minutes after
the engine stop, oil level should be between the “L”
and “F” marks in the dipstick. If low, check for leakage
and add oil up to the “F” mark.
✍
NOTICE
Do not fill with engine oil above the “F” mark.
Installation
Oil Pump
1. Before installing the oil pump and screen assembly
on the bed plate, check if the O-ring is seated
properly and not damaged.
2. Install the oil pump and screen assembly with the
specified torque.
Tightening Torque:
19.6 ~ 26.5Nm (2.0 ~ 2.7kgf.m, 14.5 ~ 19.5lb-ft)
3. Check if the oil pump works properly.
4. With the cylinder block, bed plate, crankshaft piston
assembly, connecting rod assembly and the oil pump
assembly installed, insert the crankshaft sprocket(A)
in the crankshaft, aligning the No.1 piston at the
BDC(bottom dead center).
5. Install the oil pump chain (B) and the oil pump
chain tensioner and remove the pin from the tensioner.
Tightening Torque:
7.8 ~ 11.8Nm (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)
6. Install the baffle plate (A).
Tightening Torque:
9.8 ~ 11.8Nm (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
Oil Pan
1. Install the oil pump.
2. After applying sealant (A) on the groove and
checking if the O-rings are seated securely, Install the
timing chain case assembly(C) in fifteen minutes.