Hyundai Seasall S220P, Workshop Manual, Page: 44 / 150

Engine Mechanical System
43
Cylinder block
Standard oil clearance:
0.030 ~ 0.048mm (0.0012 ~ 0.0019in)
10) If the plastic gauge measurement is too wide or
too narrow, remove the bearings and then install new
bearings with the same color mark. Recheck the oil
clearance.
◉
CAUTION
Do not file, shim, or scrape the bearings or the caps
to adjust clearance.
11) If the plastic gauge shows the clearance is still
incorrect, try the larger or smaller bearing. Recheck
the oil clearance.
✍
NOTICE
If the proper clearance cannot be obtained by using
the appropriate larger or smaller bearings, replace the
crankshaft and start the measurement from the first.
◉
CAUTION
If the marks are indecipherable because of an
accumulation of dirt and dust, do not scrub them with
a wire brush or scraper. Clean them only with solvent
or detergent. Crankshaft Journal Bore Mark Location
Crankshaft Journal Bore Mark Location
Crankshaft Main Journal Mark Location