Hyundai Seasall S220P, Workshop Manual, Page: 28 / 150

Engine Mechanical System
27
Timing System
20. Install the drive belt idler
Tightening Torque:
34.3 ~44.1Nm (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
21.Install the water pump pulley(D).
Tightening Torque:
9.8 ~ 11.8Nm (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
22. Install the power steering bracket.
23. Install the power steering pump
1) Install new O-ring of all hydraulic lines.
2) Using other oil except steering hydraulic oil may
cause noise or pump malfunction.
◉
CAUTION
Never reuse secondary O-ring or oil.
3) Check oil level after assembling the pump and
supply oil gradually.
4) Check the level of reserve tank.
5) Complete the reassembly and start the ignition. Then
check any oil leakage out of shaft. Replacement
24. Install the drive belt tensioner (A).
Tightening Torque:
72.6 ~ 84.3Nm (7.4 ~ 8.6kgf.m, 53.5 ~ 62.2lb-ft) - upper
28.4 ~ 34.3Nm (2.9 ~ 3.5kgf.m, 21.0 ~ 25.3lb-ft) – lower
25. Compressing the tensioner with a wrench in a left
hand by turning it clockwise, put on the belt lastly with
the water pump side idler.
✍
NOTICE
Conform to what is described above because tension of
the belt in this engine is higher than ones of other
engines for preventing a slip.