HP TeemTalk Terminal Emulator 7.0, User Manual

Page: 150 / 340

HP 700-92/96 Emulation
134 Setup Options
Field separator
Factory default: ^_ (i.e. US)
This specifies the ASCII character used to indicate the end of each
protected field (except the last) that is sent in Edit mode.
To change the current definition, delete the definition displayed in
the text box and type in the new one, either as the control key char-
acter equivalent or the decimal value of the ASCII character. For
example, the default ASCII character
US can be entered by typing
the characters ^ and _ , representing the keys Ctrl + _ which, when
pressed together would generate the US code.
Decimal values are entered as three-digit numbers immediately pre-
ceded by an underscore character. Values with only two digits must
be preceded by a zero. For example, the decimal value of
US is 31,
so this would be entered as _031 .
Block terminator
Factory default: ^^ (i.e. RS)
This specifies the ASCII character sent to the host to indicate the end
of a data block transmission.
To change the current definition, delete the definition displayed in
the text box and type in the new one, either as the control key char-
acter equivalent or the decimal value of the ASCII character. For
example, the default ASCII character
RS can be entered by typing
the character ^ twice, representing the keys Ctrl + ^ which, when
pressed together would generate the RS code.
Decimal values are entered as three-digit numbers immediately pre-
ceded by an underscore character. Values with only two digits must
be preceded by a zero. For example, the decimal value of
RS is 30,
so this would be entered as _030 .
Typeahead enabled
Factory default: Unchecked
When TeemTalk is connected to an HP 3000, you normally have to
wait for the host to send a prompt before you can enter new data at