HP HP 8753E, User Manual, Page: 660 / 699

The Keyword Reference
Keyword
CITIFILE
Explanation and Examples
CITIFILE A. 01.01 identifies the as a CITIflle, and indicates the
revision level of the The CITIflle keyword and revision code must
precede any other keywords. The keyword at the
of the package assures the device reading the file that the data that
follows is in the format. The revision number allows for future
extensions of the standard. The revision code shown here
following the CITIflle keyword indicates that the machine writing this
is using the version of as here. Any future
extensions of CITIflle increment the revision code.
NAME
VAR
NAME CAL-SET allows the current “package” to be named. The
name of the package should be a single word with no embedded spaces.
A list of standard package names follows:
Label Definition
RAW-DATA Uncorrected data.
DATA Data that has been error corrected. When only a
single data array exists, it should be named DATA.
FORMATTED Corrected and formatted data.
MEMORY
Data trace stored for comparison purposes.
CAL-SET
Coefficients used for error correction.
CAL-KIT Description of the standards used
DELAY-TABLE Delay coefficients for calibration.
VAR MAG 201 defines the name of the independent variable
(FREQ), the format of values in a table (MAG, if
used), and the number of data points (201). Typical names for the
independent variable are FREQ (in Hz), TIME (in seconds), and POWER
(in For the table, only the “MAG” format is
supported at this point.
1 .OEl allows variables specific to a particular type of
device to be The pound sign the device reading the
file that the following variable is for a particular device. The “NA”
shown here indicates that the information is for a Network Analyzer.
This convention allows new devices to be defined without fear of
conflict with keywords for previously devices The device
(i.e. NA) may be any number of characters.
SEG-LIST-BEGIN
SEG-LIST-END
SEG,LIST-BEGIN indicates that a list of segments for the independent
follow. Format for the segments is: [segment type] [start]
[stop] [number of points]. The current implementation only
supports a single segment. If there is more than one segment, the
construct is used. revision supports
only the SEG (linear segment) segment type.
SEG,LIST-END defines the end of a list of independent variable
segments.
The Data and Keyword Reference