HP HP 8753E, User Manual, Page: 598 / 699

Error Number There is not enough memory space for the power meter calibration array.
154 Increase the available memory by clearing one or more save/recall registers, or
by reducing the number of points.
Error Number You pressed an undefined
2
Error Number Limit lines cannot be turned on unless a limit table has been created. Refer to
205
a Device with Limit Lines” in Chapter 2 for information on how to
create a limit table.
Error Number List mode has been turned off in the frequency offset mode because it is
182 incompatible with your selected frequency.
Error Number The frequency list is empty. To implement list frequency mode, add segments
9 to the list table.
Error Number A logarithmic sweep is only valid if the stop frequency is greater than four
150 times the start frequency. For frequency spans of less than two octaves, the
sweep type automatically reverts to linear sweep.
Information The frequency domain data points must be related from dc to the
Message stop frequency. That is, stop
n
x start, where n number of points If this
condition is not true when a low pass mode (step or impulse) is selected and
transform is turned on, the analyzer resets the start and stop frequencies. The
stop frequency is set close to the entered stop frequency, and the start
frequency is set equal to stop/n.
1 Error Messages