HP HP 8753E, User Manual, Page: 619 / 699

Kit
Accurate operation of the analyzer system can be verified by measuring known devices other
than the standards used in calibration, and comparing the results with recorded data.
HP Kit
This kit contains traceable precision devices used to the system’s error-corrected
measurement uncertainty performance. included is verification data on a 3.5 inch disk,
together with a hard-copy listing. A system verification procedure is provided with this kit and
Return Cables
The RF cables are used to connect a two-port device between the test ports. These
cables provide shielding for high dynamic range measurements.
HP Port Return Cable Set
This set consists of a pair of test port return cables that can be used in measurements of
devices. They can
be used with connectors other than 7 mm by using the appropriate
precision adapters.
HP 75 Ohm Type-N Port Return Cable Set
This set consists of test port return cables for use with the HP 8753E Option 075.
Adapter Kits
HP 50 to 75 Ohm Minimum Loss Pad.
This device converts impedance from 50 ohms to 75 ohms or from 75 ohms to 50 It is
used to provide a low SWR impedance match between a 75 ohm device under test and the
HP 8753E network analyzer (without Option 075).
These adapter kits contain the connection hardware required for making measurements on
devices of the indicated connector type.
n
HP 50 Ohm Type-N Adapter Kit
n
HP 50 Ohm BNC Adapter Kit
n
HP 75 Ohm Type-N Adapter Kit
HP 75 Ohm BNC Adapter Kit
1 Compatible Peripherals