HP HP 8753E, User Manual, Page: 506 / 699

sets the frequency to sweep mode for frequency offset.
provides access to the series of menus used to perform a
complete calibration for measurement of all four S-parameters
of a two-port device. This is the most accurate calibration for
measurements of two-port devices.
measures the forward isolation of the calibration standard.
lets you enter a label for the forward match class. The label
appears during a calibration that uses this class.
specifies which standards are in the forward match class in the
calibration kit.
is used to enter the standard numbers for the forward match
(thru) calibration. (For default kits, this is the thru.)
lets you enter a label for the forward transmission class The
label appears during a calibration that uses this class.
specifies which standards are in the forward transmission class
in the calibration kit.
measures the forward frequency response in a two-port
calibration.
displays the complex admittance values of the active marker in
rectangular form. The active marker values are displayed in
terms of conductance (in Siemens), susceptance, and equivalent
capacitance or inductance. Siemens are the international units
of admittance, and are equivalent to mhos (the inverse of
ohms). The Smith chart graticule is changed to admittance
form.
(Option 010 only) turns gating on or off in time domain mode.
(Option 010 only) you to specify the time at the center of
the gate.
(Option 010 only) allows you to specify the gate periods.
(Option 010 only) allows you to specify the starting time of the
gate.
(Option 010 only) allows you to specify the stopping time of the
gate.
(Option 010 only) leads to the gate shape menu.
(Option 010 only) selects the widest time domain gate with the
smallest
ripple.
(Option 010 only) selects the narrowest time domain gate with
the largest
ripple.
010 selects an intermediate time domain gate.
Key Definitions