HP HP 8753E, User Manual, Page: 586 / 699

Error Messages in Alphabetical Order
CAL REQUIRED FOR AUX CHANNEL USE
217
calibration being active. Perform (or recall) a full calibration and
. . . . . . . .. . . . . . . . .
auxiliary channel.
ABORTING COPY OUTPUT
Information This message is displayed briefly if you have pressed to abort a copy
Message operation. If the message is not subsequently replaced by error message
number 25, PRINT ABORTED, the copy device may be hung. Press (Local) once
more to exit the abort process and verify the status of the copy device. At this
point, the copy device will probably have an error condition which must be
(For example: out of paper or paper jam.)
ADDITIONAL
Error Number Error correction for the selected calibration class cannot be computed until you
6 8
have measured all the necessary standards.
TALK WITH NOTHING TO SAY
Error Number have sent a read command to the analyzer (such as ENTER 716) without
31 requesting data with an appropriate output command (such as OUTPDATA).
The analyzer has no data in the output queue to satisfy the request.
AIR FLOW RESTRICTED: CHECK FAN FILTER
Error Number Something is restricting the air flow into the analyzer. Check for any debris and
2 0
clean or replace the fan filter.
ALL USED
Error Number You have used all of the available registers; you can store no more instrument
200
states even though you may still have sufficient memory. There are 31 registers
available, plus the present instrument state.
1 Error Messages