HP HP 8753E, User Manual, Page: 609 / 699

instrument changes that cause the analyzer sweep time to be
11 automatically increased. Some parameter changes that cause an increase in
sweep time are narrower IF bandwidth, an increase in the number of points,
and a change in sweep type.
Error Number The fractional-N and digital IF circuits have lost synchronization. Refer to the
12
HP N&work
for troubleshooting information.
Information
Message
The instrument is in a hold state and is no longer sweeping. To take a new
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Number You have improperly formatted an HP-IB command. Refer to the
3 3
and
for proper
command syntax.
Error Number The analyzer is in mode. In this mode, the analyzer cannot
3 6
control a peripheral device on the bus Use the menu to change to system
controller or pass control mode.
Error Number You have prematurely stopped a service test.
113
Error Number have set frequencies in the list that are outside of the frequency
133 range for harmonic measurements, or are greater than 3
on instruments
without Option 006. Reduce the frequency range of the list.
Error 1