HP HP 8753E, User Manual, Page: 599 / 699

Error Number All the memory in the sequence you are modifying is with instrument
132 commands.
Error Number When you use a sliding load (in a calibration kit), you must set at
71 least three slide positions to complete the calibration.
6 9
in progress. Start a new calibration.
Error Number You have no disk in the current disk unit. Insert a disk, or check the disk unit
41 number stored in the analyzer.
Service Error The self-diagnose function of the instrument operates on an internal test
Number 114 At this time, no failure has been detected.
Error Number No of the type created by an analyzer store operation were found on the
4 5
disk or the disk drive is empty. If you requested a specific title, that
was not found on the disk.
Error Number The first IF signal was not detected during pretune. Check the front panel R
5
channel jumper. If there is no visible problem with the jumper, refer to the
HP 8753E Network
for troubleshooting.
Error Messages