Temperature Control
36
5.
Select the
Experiment Type
and enter any additional experiment parameters.
6.
Click the
Advanced
button to view the
Single Channel Detector Advanced
Parameters
screen.
7.
Select the proper
Units
and
Gain
settings. Click
OK
to close the window.
8.
Click
Run
to start the experiment.
Configuring for Voltage and Current Modes
To switch Auxiliary Analog Input operation modes, two separate
Single Channel
Detector
configurations (one for
Voltage
and one for
Current
) need to be created in the
hardware configuration, both connected to the Synapse. When one of these detectors is
initialized, the Synapse will be configured as the specified voltage or current device.
Summary of Contents for JOBIN YVON SYNAPSE
