Temperature Control
34
To use the AUX port as a reference channel:
1.
Start SynerJY and open the
Experiment Setup
screen.
2.
Click the
Detectors icon
from the
General
tab. Click the
Active
check box to
activate the detector. Select the
Acquisition Mode
and
Experiment Type
and
enter any additional experiment parameters.
3.
Click the
Advanced
button to view the
Multi Channel Detector Advanced
Parameters
screen. Select the
Normalize to AUX Input
check box to enable
Normalization (uncheck the box to disable this feature). Click
OK
to close the
window.
4.
Click
Run
to start the experiment.
5.
When the Normalize function is enabled, the Synapse CCD will collect data from
the CCD and collect a reference value from the AUX IN port. The CCD data will
then be divided by the value collected from the AUX IN port and displayed on the
screen.
Summary of Contents for JOBIN YVON SYNAPSE
