11
Chapter 3: Detector System Installation
Installation Overview
Before the operational power-up phase, you must install and set up your Synapse CCD
detection system. It is recommended that you read this chapter thoroughly and follow the
steps in the order listed below for proper installation and startup.
•
Unpacking and Equipment Inspection
•
Installing Application Software
•
Mounting the Synapse Detector to a Spectrograph
•
Connecting Electrical Interface Cables
Electrostatic discharge (ESD) may damage
components of the Synapse CCD detection system if
proper precautions are not taken. The sensor and
detector head electronics are all very sensitive to ESD.
When installing the system, stand on a conductive mat
and wear a grounded ESD wrist strap. The computer
must be turned off; however, its power cord should be
connected to a grounded outlet to provide a proper
chassis to earth ground.
.
CAUTION
Note
: It must be emphasized that the HORIBA Jobin
Yvon warranty on Synapse does not cover
damage to the sensor or the system’s electronics
that arises as a result of improper handling,
including the effects of electrostatic discharge
(ESD).
Summary of Contents for JOBIN YVON SYNAPSE
