![background image](http://html1.mh-extra.com/html/horiba/jobin-yvon-synapse/jobin-yvon-synapse_user-manual_2162296069.webp)
Optimization and Troubleshooting
59
Cooling
If the detector starts to exhibit higher than normal dark current levels in the same
controlled experimental set-up, one of the following problems may have occurred:
•
The cable connections between the power supply unit and detector may need to be
secured.
•
Physical damage, such as fracturing of the window, may have caused vacuum
degradation. The cooling of the CCD sensor relies on the quality of the vacuum
(refer to the "Detector Head and Chamber Cooling Effectiveness” section of
Chapter 8). If the Synapse CCD is damaged and the vacuum is compromised, the
TEMP status LED will remain yellow, indicating that the system cannot reach the
desired setpoint. Please contact the factory for advice in the event that the system
cannot reach the setpoint within 30 minutes from power up or if physical damage
to the instrument is suspected.
Shutter
If the shutter should fail to actuate, verify that all cables are correctly connected. Contact
HORIBA Jobin Yvon for further assistance.
Power Interruption
If power is interrupted, restart the system.
Software Cannot Recognize Hardware
Configuration
•
The system’s software or firmware configuration matches the actual hardware
configuration. Refer to the software documentation for more information on
creating, editing, or loading a hardware configuration.
•
The USB 2.0 port of your computer is working properly.
•
If you have selected an appropriate hardware configuration for your system and a
device is still not found during initialization, verify that all cables are correctly
connected and that power is turned on.
Summary of Contents for JOBIN YVON SYNAPSE
