![background image](http://html1.mh-extra.com/html/horiba/jobin-yvon-synapse/jobin-yvon-synapse_user-manual_2162296025.webp)
Detector System Installation
15
Mounting Synapse to a Spectrograph
Synapse array detectors can be fitted to most HORIBA Jobin Yvon or Spex
spectrometers that are equipped with a spectrograph exit port. The detector must be
mounted in the correct orientation in order to perform properly. The following is a
standard procedure for mounting a Synapse detector to an iHR or MicroHR spectrograph.
Other spectrograph models may require a different mounting orientation. Please contact
HORIBA Jobin Yvon customer service if you need assistance mounting your Synapse to
a spectrograph.
Synapse CCDs are shipped with the CCD flange already attached to the camera. The
CCDs are focused and aligned at the factory and when installed in a spectrograph, using
the procedure below, should be properly aligned and require no further adjustments. If
using a spectrograph not manufactured by HORIBA Jobin Yvon, the flange will require
mounting to the CCD. Mount the CCD/flange assembly to the spectrograph as follows:
1.
Insert the tube of the CCD flange into the CCD port of the spectrograph. Make
sure that the flange pin is aligned with the corresponding slot.
2.
Push the flange into the spectrometer until it stops.
3.
The flange will touch the focus wheel. Rotate the CCD clockwise until it stops.
4.
Tighten the flange lock using a 2.5 mm allen key.
Figure 3.
Flange Installation (Imaging flange pictured with iHR320 Spectrograph)
Summary of Contents for JOBIN YVON SYNAPSE
