![background image](http://html1.mh-extra.com/html/horiba/jobin-yvon-synapse/jobin-yvon-synapse_user-manual_2162296020.webp)
System Requirements
10
General Maintenance Requirements
Cleaning the Detector Head
Users are recommended to periodically clean the Synapse detector by wiping it down
with a clean, damp cloth. This procedure should only be performed on external surfaces
after any supplied ESD covers have been re-affixed to their respective electrical
interfaces. Do not use any solvents, soaps, or abrasives when cleaning components as
these products can damage surface finishes.
Cleaning the Dust Cover of the Power Supply Unit
The dust cover of the power supply unit must be periodically (a minimum of once every
six months) removed and cleaned. To clean the dust cover:
1.
Make sure that the power
switch located on the
back of the power supply
unit is set to the off (“O”
symbol) position.
2.
Remove the four Phillips
head screws that secure
the dust cover to the unit.
3.
Remove the dust cover,
holding it several feet
away from the unit.
Figure 1.
Removable Dust Cover of Power Supply Unit
4.
Hold a can of compressed air about 2” away from the dust cover, and use short
blasts of air to remove all dust from the cover.
When using compressed air, read and follow the usage
information, usage directions, and caution warnings
specific to the brand of air you are using. Use the
product in a well-ventilated area and do not use near
potential ignition sources - compressed air can ignite
under certain circumstances.
.
5.
Once the cover is clean and completely dry, re-secure it to the power supply unit
using the four Phillips head screws.
CAUTION
Summary of Contents for JOBIN YVON SYNAPSE
