![background image](http://html1.mh-extra.com/html/horiba/jobin-yvon-synapse/jobin-yvon-synapse_user-manual_2162296029.webp)
19
Chapter 4: Initial Power-up and Operation
This chapter guides you through the steps necessary to initially power-up and
successfully begin to acquire spectra with a Synapse system. In addition, detector head
issues related to proper CCD focusing and alignment to a spectrograph are discussed in
detail.
A brief summary of the available data acquisition modes is also provided.
Operation of Synapse is predominantly controlled by software, and as such,
requires experimental setup and equipment configuration via SynerJY application
software. Please refer to the
SynerJY Installation Guide
and Help File for
information related to proper experiment set-up if needed.
To power-up and operate your Synapse, please follow the steps in the order listed below.
•
Initial Power-up
•
Configuring Hardware
•
CCD Focus and Alignment on the Spectrograph
•
Operation Modes
Initial Power-up
1.
Check that all system cables interfacing to and from the overall detection system
are properly connected.
2.
Verify that the Synapse power supply unit, computer, spectrograph and any
additional supporting equipment are connected properly to AC input power.
3.
Make sure that all software has been installed before the unit is turned on.
4.
Set the power switch on the back of the power supply to the
ON
(“
I
” symbol)
position.
5.
Once the power switch is activated, the LED located on the front panel of the
Synapse power supply unit will illuminate green. The PWR LED located on the
detector head will also illuminate green. The TEMP LED located on the detector
head will illuminate yellow to indicate that cooling is taking place and will turn
green once it reaches the set temperature.
6.
The computer will recognize that a new USB device has been powered up and is
connected to the computer.
7.
The
New Found Hardware Wizard
screen opens. Click
Next
.
Summary of Contents for JOBIN YVON SYNAPSE
