Appendix C: Performing Routine Procedures with SynerJY
71
Triggering
Synapse detection systems offer both input and output TTL trigger functions. Triggering
functions are software enabled. Two hardware triggers are available as SMB receptacles
on the back of the controller: one for TTL input (male) and one for TTL output (female).
Triggering can be activated at the start of each experiment or at the start of each
acquisition during the course of one experiment.
To enable triggering using SynerJY:
1.
Start SynerJY and open the
Experiment Setup
screen.
2. Select the
Triggers
tab. The Triggers window will open.
3. From the
Input Trigger
heading, click
Enable
to activate the
Input Trigger
.
4. Select the appropriate
Input Trigger
parameters.
Event
allows the user to specify
whether the Trigger will be enabled once, at the start of the experiment or at the
Summary of Contents for JOBIN YVON SYNAPSE
