2–8
Rapid fFN 10Q
System User Manual
Section 2 — Installation
FACTORY DEFAULT SETTINGS
The Rapid fFN 10Q System uses the following default settings. To customize the unit to your laboratory
requirements, refer to Section 4, Software Functions — Detailed Descriptions.
The Default Settings are as follows:
AUTOPRINT
Factory setting is Autoprint ON. After every result, the printer will generate a printed result.
DATE FORMAT
The default setting is MM/DD/YY.
TIME FORMAT
The default setting is 24 hour time.
SHUTDOWN
The system may be left plugged in and idle when not in use. If the system is to be shutdown make sure it is
idle. Move the power switch on the left side of the analyzer to the OFF position. The printer is always powered
on. To remove power from the printer, unplug the power cord from the electrical outlet.
EXTENDED SHUTDOWN
If the system is to be turned off for a long period of time, or taken out of use, power off the analyzer as described
above. Completely remove power from the device by unplugging the power cord from the electrical outlet.
Summary of Contents for Rapid fFN 10Q
Page 1: ...User Manual...
