2–4
Rapid fFN 10Q
System User Manual
Section 2 — Installation
System
Printer
Analyzer
SYSTEM SETUP
1. The Analyzer and Printer should be placed on a fl at, level surface. Verify that the power switch on the left
side of the analyzer is set to the OFF position.
Note:
Apply power to the printer before applying power to the analyzer.
Note:
Do not install any of the Dymo Label software that comes with the printer.
2. Plug the desktop power adapter output jack into the receptacle labeled 24V DC on the bottom of the
printer. Plug one end of the appropriate power cord into the desktop power adapter. Plug the other end of
the power cord into an AC power outlet. The light on the front panel of the printer shows that power is on.
3. Insert the USB cable into the receptacle labeled USB on the bottom of the printer. Route the USB cable
and the power cable through the cable channel and set the printer upright on a fl at surface. Plug the other
end of the USB cable into either of the USB ports labeled ‘Printer’ on the analyzer.
Summary of Contents for Rapid fFN 10Q
Page 1: ...User Manual...
