HIKVISION DS-K3B601S Series, User Manual

Page: 42 / 124

Chapter 5 Device Settings
After installation and wiring completed, the turnstile will learn the open and closed position
automatically.
After the learning, the turnstile is in the normal mode. You can also set the turnstile to test mode,
passing mode and memory mode, pair the keyfob, initialize the hardware, switching between
RS-485 communication mode and RS-232 communication mode, and view relay output NO/NC
diagram by setting the DIP switch on the access control board.
• Study Mode: The barrier will learn the closed position.
• Normal Mode: The device will work properly. The device will work properly. The barrier position
configured in study mode is the closed position when the device is working normally.
• Test Mode: Test mode is the same as the normal mode except that the device cannot report the
alarm, the event, or the people counting information to the center.
• Passing Mode: There are 9 passing modes, including controlled bi-direction, controlled entrance
and prohibited exit, controlled entrance and free exit, free bi-direction, free entrance and
controlled exit, free entrance and prohibited exit, prohibited bi-direction, prohibited entrance
and free exit.
• Memory Mode: By default, the memory mode is enabled. When multiple cards are presented
and authenticated, it allows multiple persons passing through the lane. When it counts the
passing people number is equal to the card presented times, or no person passing through the
lane after the last person passing, the barriers will be closed.
Note
You can also set the DIP switch on the access control board to control the entrance and exit
controlling type, keyfob pairing, etc. For details about the DIP switch value, see DIP Switch .
5.1 Set Study Mode
Enter the study mode through DIP switching to set the closed position of the device barrier.
Steps
1. Set The No.1 of the 8-digit DIP Switch on the main control board to ON by referring the
following figure to enter the study mode.
2. Adjust the closed position of the barrier.
3. Power on the device.
The device will remember the current position (closed position) automatically.
DS-K3B601SX Series Swing Barrier User Manual
28