HEIDELBERG Speedmaster CD 102, Manual

Page: 91 / 170

GR SG9015839000001000
GR SG901591
1000000000
Preset Plus Feeder
confidential
C.1.53
15.8 Adjusting the retainers
2
1
3
4
Fig. 67 Retainer on the pull lay
1. Push two strips of the currently used printing
material under both retainers.
2. Using the knurled head screw (Fig. 67/1), adjust
the height of the retainers (Fig. 67/2).
D
Retainers up = anti-clockwise.
D
Retainers down = clockwise.
The retainers must guide the strips of paper
lightly without squeezing them.
15.9 Removing/installing the retainer
1
2
Fig. 68 Removing the retainer
Removing the retainer
Caution – Press damage
Screws or small parts that get into the
press can damage the equipment seri-
ously. Ensure that screws or other
small parts cannot get into the press.
1. Loosen and remove the two screws (Fig. 67/4)
on the guide block.
2. Remove the guide block (Fig. 67/3).
3. Using the knurled head screw (Fig. 67/1), set
the retainer to the topmost position.
D
Retainers up = anti-clockwise.
D
Retainers down = clockwise.
4. Loosen the screw (Fig. 68/1) from the retainer.
Pull the screw from the top and turn it at the
same time in anti-clockwise direction until the
screw is fixed at the upper position (Fig. 68/1).
Caution – Damaged retainers can
obstruct the sheet travel
Do not bend or scratch the retainers.
Handle the retainers with extreme care
when you remove or install them.
5. Press the retainer (Fig. 68/2) down and out of
the support.
UTKSG9015100000000000010
UTKSG9015100000000000012