HEIDELBERG Speedmaster CD 102, Manual

Page: 90 / 170

Preset Plus Feeder
confidential
C.1.52
4. Place a sheet onto the feed table. The sheet
must be in contact with the front lays and the
pull stop.
5. Turn the knurled head screw (Fig. 66/1) towards
D
pull lay on O.S. - white arrow,
D
pull lay on D.S. - black arrow,
until the display on the MID (Fig. 65/1) disap-
pears.
6. Turn the knurled head screw in the opposite
direction, until the display on the MID (Fig. 65/1)
lights up.
Basic adjustment:
Continue turning the knurled head screw by
10 notches.
Tip
The sensitivity of the monitor de-
creases with the number of notches
you turn the screw (larger pull error
possible).
The sensitivity of the monitor increases
if you reduce the number of notches
you turn the screw.
Example: One notch corresponds to 0.03 mm.
In basic adjustment, a pull error is re-
ported if the distance between sheet
and sheet stop is more than 0.3 mm
after pulling. The infeed warning
sounds if the pull distance is
≤
0.3 mm.
15.7 Adjusting the pull distance
Once the format of the printing material has been
entered, the control system automatically adjusts the
pull lays to the preselected pull distance. The pull
distance can manually be adjusted at the CP2000
Center, at the feeder console and at the feeder con-
trol panel on D.S. (see chapter ”B, Printing a job”).
Recommended settings
Paper of less than 200 g and cardboard of more than
200 g to 4...6 mm.
UTKSG9015100000000000009