HEIDELBERG Speedmaster CD 102, Manual

Page: 56 / 170

GR SG9015912000000000
Preset Plus Feeder
confidential
C.1.18
15 mm
7 mm
1
Fig. 20 Forwarding flap diagram
Switching on automatic mode
Note
The detection range of the pile height
control begins approximately 15 mm
under the forwarding flap, and ends
approximately 7 mm above it.
The current measured value is set as
the new setpoint value if the front edge
of the pile is inside this measuring
range when automatic mode is
switched on.
The setpoint value last selected is
used if then front edge of the pile is
outside the measuring range.
Pressing the Front edge pile height control button
(Fig. 19/3) toggles between automatic mode and
manual mode.
1. Press the Front edge pile height control button
(Fig. 19/3) until the LED in the button is ON.
The automatic front edge control mode is ac-
tive.
Automatic mode – changing setpoint
You can select a setpoint value in the range between
approximately 3 mm above the forwarding flap and
approximately 10 mm below the forwarding flap.
Condition
Automatic front edge control mode is
active and the front edge of the pile is
inside the measuring range of the pile
height sensor.
D
Press the Suction head height adjustment up
button (Fig. 19/1) to increase the setpoint value.
D
Press the Suction head height adjustment down
button (Fig. 19/2) to decrease the setpoint
value.
Note
Hold the button down until the required
value appears on the display and the
suction head height and pile height
have been set.
The current setpoint value is displayed on the MID.