HEIDELBERG Speedmaster CD 102, Manual

Page: 46 / 170

GR SG9015891000000000
Preset Plus Feeder
confidential
C.1.8
2
1
Fig. 8
End of run reached ?
14. Remove the non-stop bar from the feeder. Tilt
the non-stop bar against the running direction of
paper and remove the non-stop bar from the
top from the retainers on D.S. and O.S.
Store the non-stop bar in the retainer (Fig. 8/1)
on the feeder.
15. Press the Auxiliary pile up button (Fig. 4/1) to
move the non-stop bar to the topmost position.
This completes the non-stop cycle.
Note
Pile support plate and non-stop bar can-
not collide. If you do not raise the non-
stop bar manually, it will be moved up-
wards as a function of the upwards
motion of the pile support plate.
Feeder stop if the residual pile is too small
When the auxiliary pile reaches the upper end of the
black scale, the pile transport of main pile and auxil-
iary pile and the feeder are switched off.
1. Lower the auxiliary pile by approximately 2 cm
(Fig. 4/2).
2. Press the Main pile up button (Fig. 4/3) until the
supporting members are in contact with the
main pile.
3. Pull out the supporting members.
4. Press the Main pile up button until the pile
stops.
5. Switch on the sheet travel.