GVS K-BUS
○
R
KNX/EIB
Thermostat
www.video-star.com.cn
Tel.
：
（
8620
）
39338986
Fax.
：（
8620
）
39338465
32
If the values of dead zone is 3
℃
, temperature setpoint of heating comfort mode is 22
℃
, that means
the temperature setpoint of the cooling comfort mode is 25
℃。
——
Parameter of “setpoint increase for standby mode at cooling in 0.1Celsius”
option
：
0…100
The parameter is use for setting the increment that decides the stand by mode’s temperature
setpoint which is changed with the comfort temperature setpoint under the circumstance of cooling
function. For example: if setting the increment of 3
℃
, when the comfort temperature setpoint is 23
℃
, the
stand by mode’s temperature setpoint will be 26
℃
.
——
Parameter of “setpoint increase for night mode at cooling in 0.1Celsius”
option
：
0…100
The parameter is use for setting the increment that decides the night mode’s temperature setpoint
which is changed with the comfort temperature setpoint under the circumstance of cooling function. For
example: if setting the deduction of 2
℃
, when the comfort temperature setpoint is 23
℃
, the night mode’s
temperature setpoint will be 25
℃
.
——
Parameter "setpoint heat protection at cooling in 0.1Celsius"
Options: 0 ... 500
This parameter is used to set the temperature setpoint for overheat protection. In the overheating
protection mode of cooling function, the temperature is not allowed to be higher than the set-temperature,
otherwise the Thermostat will trigger a control telegram to so that the corresponding Cooling actuator
start cooling the room to avoid temperature to be over high.
When the parameter "Setpoint adjustment" select "absolute adjustment", the following
parameters are visible, to set the temperature setpoint of absolute adjustment.
——
Parameters "Heating comfort setpoint in 0.1Celsius"
Options: 0-500
Here it sets the temperature setpoint of heating function under Comfort Mode.Unlike that of relative
