GK600E User Manual
Chapter 6 List of Parameters
- 85 -
Parameter
Designation
Scope
Factory
default
Attr
1: Virtual terminal in effect
Ones place: BIT0~BIT3: X1~X4
Tens place: BIT4~BIT6: X5~X6, EX
Hundreds place: BIT8~BIT10:
AI1~AI2, EAI (EX and EAI located at
IO option board)
C0-21
Enabled condition of run
command terminal after
fault reset (RESET)
0: Trigger edge de ON
detected
1: ON detected
0
△
Group C1 Digital Output
C1-00
Y1 output function
0: No output
1: Drive undervoltage
2: Drive run preparation completed
3: Drive is running
4: Drive running at 0Hz (there is no
output at stop)
5: Drive running at 0Hz (there is
output at stop)
6: Run direction
7: FREQ attained
8: Upper limit FREQ attained
9: Low er limit FREQ attained
10: Frequency detection FDT1
11: Frequency detection FDT2
12: Reserved
13: Torque limited
14: Fault output
15: Alarm output
16: Drive (motor) overloaded alarm
17: Drive overheat alarm
18: Zero current detection
19: X1
20: X2
21: Motor 1/ 2 indication
22: Set count value attained
23: Designated count value attained
24: Length attained
25: Consecutive run time attained
26: Accumulative run time attained
27: Brake control
28: Reserved
29: Reserved
14
△
C1-01
Y2/DO output function
(w hen used as Y2)
0
△
C1-02
Control board relay output
function
27
△
C1-03
Option board relay output
function
35
△
