GSK 218M, Connection And Plc Manual

Page: 82 / 227

GSK218M CNC System Connection and PLC Manual
79
automatic operation.
［
Output conditions
］
These signals are 1 when:
When cutting feed is being performed by automatic
operation(cutting feed for linear interpolation, circular
interpolation, helical interpolation, thread cutting, skip cutting,
or cutting in canned cycle).
Note:
Do not output the signal in the state of feed hold.
Output the signal during the interlock or the feedrate override is set to 0.
Signal address
2.9 VRDY OFF alarm ignore signal
General
The German VDE safety standard requires that the motor be deactivated when the
safety guard is opened. By using the VRDY OFF alarm ignore signal, however, the
CNC can be restarted without resetting, even if the safety guard has been opened.
Signal All-axis VRDY OFF alarm ignore signal
IGNVRY<G009#3>
[Classfication]
Input signal
[
Function
]
Disables the check of servo alarm VRDY OFF.
[
Operation
]
When the signal is set to logical 1, the control unit operates as follows:
Even when the servo amplifier ready signal goes off, the control unit,
however, sets ervo ready signal SA to 0. The SA signal can remain set to
0.
Signal address
2.10 Abnormal load check
General
Machine collision, defective, and damaged tools cause a large load torque on the
CUT RPDO
F002
＃
7
＃
6
＃
5
＃
4
＃
3
＃
2
＃
1
＃
0
IGNVRY
G009
＃
7
＃
6
＃
5
＃
4
＃
3
＃
2
＃
1
＃
0