GSK 218M, Connection And Plc Manual

Page: 148 / 227

GSK218M CNC System Connection and PLC Manual
145
the previous one.
Insert element: position the cursor to the required, press <
INSERT
> to insert empty position,
and then add the new element as the above method. The cursor can insert
orderly. (Note: ensure the indicator above <
CTRL
> key is OFF when inserting
element.)
Delete element: press <
DELETE
> to delete the current element and the following one will
orderly move forward(Note: ensure the indicator above <
CTRL
> key is OFF
when deleting element.)
Add vertical conductive line: press
【 】
to add one vertical conductive line under the
lower-right of current cursor position.
Delete vertical conductive line: press
【 】
to delete one vertical conductive line under the
lower-right of current cursor position.
Add horizontal conductive line: press 【 —— 】 to add one horizontal conductive line before the
cursor position, if the current position has element, the
horizontal conductive line replace the element.
Insert line: position the cursor to the any line of target line, press <
CTRL
>, and then press
<
INSERT
> after the indicator above <
CTRL
> is ON, insert the blank line at the
place above of the specified line by cursor, and the sequent line will orderly move
down one line.
Delete line: position the cursor to the target line, press <
CTRL
>, and then press <
DELETE
> to
delete the current line after the indicator above <
CTRL
> is ON, and the sequent
line will orderly move up one line.
Delete block: position the cursor to the initial position which will be deleted, press <
L
> and
input the address number of target block’s coil, and last press <
ALT
>.
Copy block: position the cursor to the block head(first contact of left busbar) which will be
copied, press <
M
> and input the block end(address number of coil of right
busbar), and last press <
ALT
>.
Copy block: position the cursor to the block head(first contact of left busbar) which will be
copied, press <
T
> and input the block end(address number of coil of right busbar),
and last press <
ALT
>.
Paste block: position the cursor to the any line of target line, press <
F
>, and then press <
ALT
>.