GSK 218M, Connection And Plc Manual

Page: 205 / 227

GSK218M CNC System Connection and PLC Manual
202
open close
K0106 Whether the tool origin point setting is enabled Disabled Enabled
K0107 Whether the tool magazine enters the
regulation mode
No Yes
K0110 Whether the manual tool clamping/releasing
prompts the tool number which corresponds
to the spindle Yes No
K0111 Whether the manual operation returns the tool
change position No Yes
K0112 Reversed
K0113 Reversed
K0114 Reversed
K0115 Reversed
K0116 Reversed
K0117 Reversed
KAPA use notes:
1. When the system normally runs, K0000, K0001, K0002, K0003, K0004, K0005, K0006,
K0007, K0052, K0107 must be 0, otherwise there may be the unexpected accidence.
2. The modified K0010 is valid when the system is started agine, when K0010=0(i.e. the tool
magazine is not used)
3. When K0010=1(i.e. the tool magazine is enabled), K0082 setting is disabled.
4. When K0082=0(i.e. the tool clamping/releasing device is used), K0081 setting is disabled.
5. K0060 setting:
When two travel limit switches on X axis have been installed (the positive limit switch
connects with X0.0, the negative limit switch connects with X 0.1) , K0060 set to 0 is enabled,
and K0070 setting is disabled.
When one travel limit switch on X axis is installed (connecting with X0.0) k0060 set to 1 is
enabled,
When the system alarms or X axis moves in the negative direction to the limit, the system
alarms for the positive direction, when the K0080 is modified, the alarm reverses, namely, the
error alarm is regulated.
The settings ofK0061 and K0071 on Y axis, K0062 and K0072 on Z axis, K0063 and K0073
on the 4
TH
axis are the same that of X axis.
6. When K0083=0, the lubricating ON/OFF time is controlled by the system, i.e. by regulating
CTR101( lubricating OFF time: default: minute) and CTR102(lubricating ON time: default:
second), when K0083=1, the lubricating is not controlled by the system.
7. K0052=1, all alarm interlocks are released, and the system enters the debugging mode,