GSK 218M, Connection And Plc Manual

Page: 130 / 227

GSK218M CNC System Connection and PLC Manual
127
Tapping signal During the tapping cycle, output the tapping signal. When the
tapping cycle G code is valid, CNC also outputs the tapping
signal.
Override During the tapping, the cutting feedrate override is always set to
100%.
Feed hold During the tapping, the traverse does not stop immediately when
the feed hold is pressed down. But it stops when the tool returns
to R level.
Dry run TDR (parameter 12#5) defines if the dry run is valid during the
tapping.
Signal Tapping signal
TAP
＜
F001
＃
5
＞
[
Classfication
] Output signal
[
Function
] The signal reports CNC is during tapping mode.
[
Output conditions
] The signal is 1:
－
CNC is during the tapping cycle mode G74, G84.
－
CNC is during the tapping cycle mode G63. the signal is set to 0:
－
CNC is not tapping cycle and tapping mode.
－
The reset or emergency stop signal is input.
Signal address:
11.3 Metric/Inch conversion
General Either inch or metric input can be selected by G code.
Signal Inch input signal
INCH
＜
F002
＃
0
＞
[Classfication] Output signal
[Function] This signal reports that inch input mode is active.
[Output conditions] “1” reports that the inch input mode (G20) is during progress, and
“0” reports that metric input mode (G21) is during progress. This
signal changes to the corresponding state when modes are
switched using the setting data display on the MDI panel.
Signal address
Parameter
INCH
F002
＃
7
＃
6
＃
5
＃
4
＃
3
＃
2
＃
1
＃
0
INI
0000
＃
7
＃
6
＃
5
＃
4
＃
3
＃
2
＃
1
＃
0
TAP D TAP
F001
＃
7
＃
6
＃
5
＃
4
＃
3
＃
2
＃
1
＃
0