GSK 218M, Connection And Plc Manual

Page: 216 / 227

GSK218M CNC System Connection and PLC Manual
213
Troubleshooting: rotate the tool magazine to ensure the tool number on the spindle is the same
that of current tool magazine.
Alarm information: 1251 please turn off the power supply
Fault cause: the modified parameter is enabled after power-off.
Troubleshooting: start the system again.
Alarm information: 1252 Z axis cannot move because the tool is clamped.
Fault cause: when the tool is in the infeed position and the spindle tool is clamped, Z axis moves.
Troubleshooting: 1. the tool magazine is in the retraction position.
2. the spindle tool is released.
Alarm information: 1253 carefully operate the system because the tool magazine is in the debug
mode.
Fault cause: When K0107 is set to 1, the system alarms, which prompts the tool magazine enters
the debug mode, and which is not related to its other alarms and interlock signal, at
this time, we should carefully operate the system, otherwise, there maybe damage
the machiney.
Troubleshooting: press “RESET”.
Alarm information: 1254 the system cannot execute the cycle start
Fault cause: when K0107 is set to 1, the “CYCLE START” is pressed in AUTO or MDI or DNC
mode, which causes the system alarms.
Troubleshooting: set K0107 to 0.
Alarm information: 1255 the tool cannot return to the orgin point because it is clamped.
Fault cause: Z axis is executed to return to the origin point when the tool magazine is in the
infeed position and the spindle tool is clamped.
Troubleshooting: 1. the tool magazine is in the retraction position.
2. the spindle tool is released.
Alarm information: 1256 the tool cannot return the tool change position because it is clamped.
Fault cause: Z axis is executed to return to the tool change position when the tool magazine is in
the infeed position and the spindle tool is clamped.
Troubleshooting: 1. the tool magazine is in the retraction position.
2. the spindle tool is released.