4-5
Supplement
If the settngs value s set to an area between
+1.0 mm and +10.00 mm, transfer drecton of
the cuttng area wll also expand 5 mm forward.
The default area whch can be set s +10.0 to
-10.0 mm.
4
Press the POSITION (
) key and ncrease or decrease the
settng value.
Supplement
It wll return to AREA PARAMETER screen (1/1)
wthout changng the settngs when you press
the POSITION ( ) key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Settng wll be set, and t wll return to AREA PARAMETERS settng
screen (1/1).
6
Press the [PAUSE/MENU] key.
It wll return to default screen.
Setting Length of the Page
Length of 1 page when usng the roll meda s set.
Only the part that will fit in to the set page length will be cut for the cutting data that is longer than the set page
length, and the exceedng part wll not be cut.
Reference
Default page length s 3 m. When dong long cuts, set the page length. Check the settng of the page length when cuttng long length.
* Be sure to use the basket.
For the CE6000-120AP, the page length up to 50 m can be set. We gve qualty assurance for page feedng up to 3 m. (Under the
condton that the meda descrbed below s used.)
• Be sure to use the basket.
• Meda: genune Graphtec brand products
• Settng Condtons: Speed under 30, acceleraton under 2.
• Perform pre feed for the amount to be used before cuttng.
• Leave the meda n envronment to use for adequate tme f the devaton of temperature and humdty s bg.
• Set the both push rollers at least 15mm nsde the edge of meda.
• The paper needs to be reset after cuttng 5 consecutve pages.
• Each page should be removed from the basket after t has been cut.
When settng meda for long-plottng, set the tenson on the left and rght of the wdth of the meda to a unform value. If t s not
unform, the meda may be removed from the roller that presses t durng plottng.
Make sure to level the whole of the meda to get rd of unevenness before cuttng. (See "Settng the number of pre feeds"
P.4-7
).
Also, pre feedng can be done automatcally when the data s receved (see "Perform Automatc Pre Feed When Cut Data s
Receved"
P.7-4
), or done automatcally when the meda s loaded (see "Perform Automatc Pre Feed When Meda s Set (Intal
Feed)"
P.7-6
).
* Pre feeding will stabilize the feed by acclimating the media, taking out the slack.
Ths settng s mantaned even after the power s turned off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen s dsplayed.
MENU screen
(Smple menu)
MENU screen
(Normal menu)
