2-42
Confirm the Results of the Cutting Test
Confirm the cutting test results, and adjust to optimal setting. Repeat cutting test and adjustment until optimal cut
s acheved.
Adjustment of Offset
Check the corners of the trangles and rectangles. See "Settng the Tool Condton"
P.2-30
and adjust the
offset value f the corner s not cut or f t s cut too much.
Supplement
How to check offset:
Check f the offset value s set correctly by followng.
Not enough adjustment.
Increase the offset value.
Optmal offset value.
Too much adjustment.
Decrease the offset value.
Check the UP length when cuttng.
When the UP length s not enough, those that
are cut durng cuttng, may come off.
UP length
Adjustment for Cutting Out
Adjust so the meda s completely cut out.
If the media is not completely cut, either the FORCE setting is too low or the cutter blade tip is not sufficiently
extended.
See "Adjustng the Blade Length"
P.2-2
and "Settng the Force"
P.2-35
and adjust the settngs.
Adjustment When Using Plotting Pen
Adjust the FORCE so there wll be no fant lnes. To prolong the pen lfe, set the FORCE to the lowest settng
wthout any fant lnes. See"Settng the Force"
P.2-35
or settng the FORCE.
